Sauder 102795 Instrucciones De Montaje página 15

Step 12
Carefully stand your unit upright.
å
Push the RUBBER SLEEVES (P) over the METAL PINS (O).
å
Insert the METAL PINS into the hole locations of your choice
in the ENDS (A2 and AA). Set the ADJUSTABLE SHELVES (C)
onto the METAL PINS.
Do the ADJUSTABLE SHELF MOLDINGS (G)
look too short? They should measure almost
25 1/8". Try the tips listed below.
If there is a 3/4" gap between the
ADJUSTABLE SHELF MOLDINGS and the
END MOLDINGS, then the END MOLDINGS
are on wrong. Refer back to Steps 6 and 7.
If there is a 1/4" gap between the
ADJUSTABLE SHELF MOLDINGS and
the END MOLDINGS, then adjust the END
MOLDINGS in until the gap is closed.
Adjust the END MOLDINGS (E and F) tight
against the ADJUSTABLE SHELF MOLDINGS (G).
www.sauder.com/services
AA
G
F
G
A2
E
G
O
P
(12 used)
102795
Pro Tip: Lift with your
legs. And, you know,
your arms.
C
AA
C
F
C
E
A2
Curved edge
Page 15