Assembly; Carton Contents - Briggs & Stratton 073000 Manual Del Operario

ASSEMBLY

Your water pump requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any questions regarding the assembly of
your water pump, please call the helpline at
1-800-743-4115. If calling for assistance, please have
the model, revision, and serial number from the serial
number label available. See "Know Your Water Pump"
for location.
Unpack Water Pump
1. Remove everything from carton.
2. Ensure you have all included items prior to
assembly.

Carton Contents

Items in the carton include:
• Water pump
• Oil bottle (SAE 30)
• Suction hose
• Parts bag (which includes the following):
• This operator's manual
• Strainer basket and barb
• Hose barb (2)
• Barb cuff (2)
• Rubber seal (2)
• Hose clamp (3)
• 1" Garden hose adapter
• Oil measure cup
If any of the above parts are missing or damaged, call
the helpline at 1–800–743–4115.
Add Engine Oil
CAUTION!
Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
1. Lay water pump in level position on side with fuel
and oil fill facing up (Figure 1).
Figure 1 - Water Pump in Level Position on Side
2. Use a rag to clear dirt and debris from around oil
fill and remove oil fill cap.
NOTE: See the section "Oil" on page 15 to review oil
recommendations. Verify provided oil bottle is correct
viscosity for current ambient temperature.
3. Keeping engine level, slowly pour entire contents
of provided oil bottle (3 oz.) into oil fill opening.
4. Replace oil fill cap and fully tighten.
5. Return water pump to normal operating position.
Add Fuel
All fuel is not the same. If a starting or performance
problem is encountered immediately after new fuel has
been used, try another service station or change
brands.
NOTE: This engine is certified to operate on gasoline.
Exhaust Emissions Control System: EM (Engine
Modifications).
WARNING
Fuel and its vapors are extremely flammable
and explosive.
Fire or explosion can cause severe burns or
death.
WHEN ADDING FUEL
• Turn water pump OFF and let it cool at least 2 minutes
before removing fuel cap. Loosen cap slowly to relieve
pressure in tank.
• Fill fuel tank outdoors.
• DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
• Keep fuel away from sparks, open flames, pilot lights,
heat, and other ignition sources.
• DO NOT light a cigarette or smoke.
6
ASSEMBLY