Total TS2081006 Manual De Instrucciones página 7

Technical specifications
Model No. TS2081006
Voltage 220-240V~50/60Hz
Rated power 800W
No-load speed 800-3000/min
Cutting capacity:Wood 110mm
Alu 12mm
Steel 8mm
Angular cutting range 0±45°
Model No. TS2081006-6
(ISRAEL Plug)
Voltage
Rated power
No-load speed
Cutting capacity:Wood
Alu
Steel
Angular cutting range
OPERATION
Fitting The Saw Blade(see Dia 2)
When changing blades, set
pendulum action switch to "0"
To open the blade holder, rotate the ring
anti-clockwise (jig saw upside down) and hold in
position. Then fully insert the blade into the
blade holder slot with blade teeth facing forward
and release the ring, which will self rotate and
clamp over the top of the blade. Push the blade
into the blade holder again to ensure it is locked
in position. Ensure the edge of the blade is
located in the groove of the support roller. To
remove blade, hold the blade and rotate the
ring anti-clockwise then lift out the blade.
Warning:
Blade teeth are very sharp.
Blade self-eject out swiftly. Do not point
at people
Note: Remove clear blade gurad to
ease the fitting/removing of blades.
UTS2081006
110-120V~50/60Hz
800W
800-3000/min
4˝
15/32˝
5/16˝
0±45°
TS2081006-8 TS2081006S
(BS Plug) (SAA Plug)
220-240V~50/60Hz
800W
800-3000/min
110mm
12mm
8mm
0±45°
Using the parallel guide(see Dis 3)
The parallel guide allows you to make an
accurate parallel cuts using the metric scale.
Release the quick set mechanism on the
oarallel guide. Put it into the required position
and lock quick set mechanism again. Slide the
parallel guide in from the appropriate side(left
or right) accordingly.Make sure that the guide
surface of the parallel guide points downwards.
Assemble vacuum chip extraction
adaptor:
Note: only use the equipment with a compatible
vacuum chip extractor, insert the extractor into
the back of the jig saw, rotate the vacuum hose
to the extraction nozzle and test whether it is
securely held in place. See Dia 4.
Operating the Trigger Switch (see Dia 5)
To operate the Pendulum jig saw, depress
the trigger switch.If you wish to use the
Pendulum Jig saw continuously, the trigger
lock button can be pushed in after the trigger
switch has been depressed. To release the lock
button push in the trigger switch again.
7