Publicidad
Idiomas disponibles
Idiomas disponibles
Angular Cutting
The angle adjustment screw has combined
with the lever.To adjust the angle of inclination,
loosen the angle adjustment screw by turning
the lever anticlockwise. See dia 8.
Dia 8
You will then be able to rotate the base plate to
the required angle 0~ 45
Angle of inclination numbers are stamped onto
the fan shaped bracket on back of the base plate
to help you set the correct angle. Check the
support roller before tightening. Firmly tighten
the angle adjustment screw by turning the
lever clockwise for operation. See dia 9
Back of Jig saw
Disengage and set the lever to touch the
saw body, or the lever will hit the workpiece.
O
to the left or right.
Dia 9
Note: To achieve a sufficient looseness or a
good tight fit of the base plate, you may need to
turn the lever repeatedly when loosening/
tightening the angle adjustment screw. The
lever has an engagement/disengagement system.
Pull the lever backwards to disengage whilst
the lever is turned to the leftmost or
rightmost position, and then reverse the lever,
further tighten/loosen the screw as necessary,
see dia 10.
Dia 10
9
Publicidad
