Installing The Belt Clip; Installing The Cap Over The Universal Connector; Installing The (Optional) Speaker/ Microphone Or Headset - Kenwood TK-5220 Manual De Instrucciones

INSTALLING THE BELT CLIP

Attach the belt clip using the supplied
M3 x 8 mm screws.
Note: If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.
Do not use glue which is designed to prevent screw loosening when
installing the belt clip. Acrylic ester, which is contained in these
glues, may crack the transceiver's back panel.
INSTALLING THE CAP OVER THE UNIVERSAL
CONNECTOR
Insert the cap into place over the
universal connector and secure it
in place using the attached screw.
INSTALLING THE (OPTIONAL) SPEAKER/
MICROPHONE OR HEADSET
1 Insert the guide of the
speaker/ microphone or
headset connector into place
over the universal connector.
2 Secure the connector in place
using the attached screw.
Note: When not using an optional
speaker/ microphone or headset,
install the cap over the universal
connector.
Belt clip
M3 x 8 mm screws
Universal
connector cap
Optional
speaker/ microphone
3