Makita CML01 Manual De Instrucciones página 10

3. Attach the cord to the cord holders as shown in
the figure. Open the plug cover, then align the arrow
mark on the socket with that on the machine, and then
insert the socket into the plug all the way.
► 1. Plug cover 2. Arrow mark 3. Socket 4. Cord
NOTICE:
Do not insert the socket forcibly. If
the socket cannot be inserted easily, it is not being
inserted correctly.
NOTICE:
When disconnecting the socket from
the plug, do not hold the cord but hold the socket.
Otherwise, the cord may be damaged and cause a
malfunction of the machine.
4. Open the lock key cover, then insert the lock key
in the place shown in the figure as far as it will go, and
then close the lock key cover.
1
2
► 1. Lock key 2. Lock key cover
To remove the portable power pack, perform the instal-
lation procedure in reverse.
For PDC01
NOTE: Before installing the portable power pack to
the machine, install at least one battery to battery port
1 or 2, and at least one battery to battery port 3 or 4.
1
1. Place the cord of the portable power pack as
shown in the figure.
2
3
4
► 1. Portable power pack 2. Cord
2. Install the portable power pack to the machine
as shown in the figure. Lock the locking levers on both
sides of the portable power pack.
► 1. Battery support lever 2. Locking lever 3. Portable
power pack
CAUTION:
pack is securely locked to the battery support
levers and the locking levers are securely locked.
10 ENGLISH
2
1
Make sure that the portable power
1
2
3