Autoadapt Turny Evo Manual De Instalación página 24

24
Turny Evo Getting seated
Installation
1. Fit wiring in the car
Fit wiring for the hand held control, door switch, ground and 12V. The illustration
below shows the associated connection points in the unit.
For a complete wiring diagram, see the back of the manual.
A / Option
- optional function
B / Lower anchor point
- is connected later
C / Female connector
- is connected later
C
B
A
Note!
Next to the swivel motor there is a rolled cable. This cable is for a future accessory
and is not used at present.
2. Install the bracket in the car
To install Turny Evo a bracket between the product and the floor of the car is re-
quired. We recommend a car specific bracket. In cases where there is no car specific
bracket, a universal bracket is available. For a range of brackets, please see
dealerweb.autoadapt.com
To install the bracket, follow the relevant instructions that accompany the bracket.
Hand held control
The small magnet is for hanging up the hand
held control. Position in a suitable place in the
car's panel and tightly screw from the back.
Door switch
Black cable
Adjust the length of the cable and connect
to the negative pole on the car battery.
Red cable 12V
Adjust the length of the cable and connect to
the positive pole on the car battery. Wire in
the supplied fuse in close proximity to the car
battery.