Publicidad
Idiomas disponibles
Idiomas disponibles
ETA SYSTEMS - UNINTERRUPTIBLE POWER MANAGER
Do not dispose of batteries in a fire. There is a danger of explosion. Do not dispose of
batteries in an environmentally unfriendly manner. Batteries may be returned to ETA
SYSTEMS for proper disposal.
Do not open or mutilate the batteries. This may release electrolyte that is toxic to the
environment and harmful to the skin and eyes.
Replacement batteries may be ordered from ETA SYSTEMS by phone at (800) 321-
6699. If purchasing batteries from another source, be sure to use the type and
quantity of batteries described in the table in Section 10.
8.0 – USER REPLACEABLE BATTERY
Please note: Changing the batteries in this UPM is designed to be a safe and simple procedure. Batteries
may be replaced while the UPM is on and providing power to the connected load. You should remember,
however, that if a power outage occurs after the old batteries are disconnected and before the new batteries
are installed, power will be lost to your connected system and components.
Please note: If you have read and understood the cautions preceding this section, you may proceed with
the following steps. Consult Figure 6 to assist you in the following battery replacement procedure.
Battery Replacement
1.
Remove the two small screws from the bottom of the front panel that secure the front panel to the frame
of the UPM.
2.
Carefully slide the front panel off the UPM taking care not to damage or tear the ribbon cable that
connects the front panel "dashboard" display to the UPM.
3.
Remove the screw(s) that secures the battery assembly retaining bracket, remove it from the unit, and
set it to one side.
4.
Slide the battery pack from the UPM by pulling on the tab provided.
5.
Disconnect the battery from the UPM by pulling apart the wire leads at the connector(s) provided.
6.
Connect the new battery pack to the UPM by reconnecting the connector(s) making sure to observe
proper polarity (i.e. black to black and red to red).
16
Publicidad
