ETA Systems 350VA Manual Del Usuario página 5

ETA SYSTEMS - UNINTERRUPTIBLE POWER MANAGER
PLEASE NOTE:
Do not disassemble the UPM
Do not attempt to power the UPM from any receptacle except a properly
grounded receptacle that matches the input plug provided with the UPM.
Do not place the UPM near water or in environments of excessive humidity.
Do not allow liquid or any foreign object to get inside the UPM.
Do not block air vents on the side of the UPM.
Do not plug appliances such as hair dryers, fans, heaters, etc. into the UPM.
Do not place the UPM under direct sunshine or close to heat emitting sources
(excessively warm temperatures will shorten battery life).
This UPM is intended for installation in a temperature controlled, indoor area
free of conductive contaminants.
The AC power supply for the UPM should be conveniently near the UPM and easily accessible –
avoid extension cords or temporary power strips to power the UPM.
The total leakage current of the UPM and consumer connected equipment should not exceed 3.5
mA.
The battery should be disconnected from the UPM by unplugging at its quick connectors when
maintenance or service work inside the UPM is necessary.
Do not dispose of batteries in a fire – batteries may explode.
Do not open or mutilate batteries. Doing so may release electrolyte or other toxic substances,
which may be harmful to the skin, eyes, or the environment.
A battery can present a risk of electric shock and high short circuit current. The following
precautions should be observed when working with batteries:
Remove watches, rings, or any other metal jewelry or objects which may make contact with the
battery.
Use tools with insulated handles.
A certified detachable power supply cord is to be used with this equipment. For the 350, 500,
and 800 VA models, a type not lighter than SJT 18AWG should be used. For the 1100 and 1440
3