Hilti POS 15 Manual De Instrucciones página 57

en
NOTE
Layout values on the building control line in a forwards or backwards direction from the tool station are line (longitudinal)
values and those to the right or left of the building control line are offset values. Forwards and to the right are positive
values, backwards and to the left are negative values.
Direction to the layout point
Using this screen, the tool is aimed at the point to be laid out by rotating the tool until the red direction indicator is
at the zero position and, below this, the numerical display for angle difference shows a value as close as possible to
zero. The cross hairs are then aimed at the point to be laid out and the reflector bearer can be guided into position.
Alternatively, the reflector bearer can bring himself into position on the sighting line with the aid of the guide light.
52
Return to previous view.
Confirm entry and continue,
showing display for aligning the
tool with the point to be staked
or marked out.
Return to entry of layout values.
Measure distance and continue,
showing layout corrections.