Hilti POS 15 Manual De Instrucciones página 64

NOTE
The procedure for setting up the station is the same as for setting up the station "anywhere" with building control
lines, with the difference that the first reference point is set at the zero point of the building control line system in the
vertical plane and the second reference point defines the direction of the vertical plane relative to the tool system. In
any case, the horizontal and vertical control lines are adopted from point (1).
Shifting a control line
In order to shift the control line system or, respectively, the "zero point" on the vertical reference plane, shift values
require to be entered.
These shift values can be used to shift the zero point of the control line system to the left (-) and right (+) horizontally,
up (+) and down (-) vertically, and the entire plane forwards (+) and backwards (-).
It can be necessary to shift a control line when the "zero point" cannot be sighted directly as the first reference point.
An existing reference point than has to be used and then shifted onto a control line by entering the applicable shift
values (distances).
Entering a layout position
The layout value is entered as a dimension relative to the reference axis or building control line in the vertical plane
that was defined when the station was set up.
Direction to the layout point
Using this screen, the tool is aimed at the point to be laid out by rotating the tool until the red direction indicator shows
"zero".
The cross hairs are them aimed in the direction of the point to be laid out.
The telescope can then be moved vertically until both triangles are shown as unfilled outlines.
NOTE
If the upper triangle is solid - move the telescope downwards. If the upper triangle is solid - move the telescope
downwards.
Cancel and return to previous
screen.
Confirm entry and continue with
entry of layout values.
Cancel and return to the start
menu.
Enter reference plane shifts.
Confirm entry and continue,
showing display for aligning the
tool with the point to be staked
or marked out.
en
59