Hilti POS 15 Manual De Instrucciones página 65

Where possible, the person holding the rod can move into position on the sighting line with the aid of the guide light.
en
Layout corrections
Using the corrections displayed, the target bearer or target is guided Up, Down, Left, Right into position.
With the aid of distance measurement, a correction Forward or Back can also be made.
The corrections shown are updated after each distance measurement until, step by step, the final position is reached.
Instructions displayed concerning movement of the target to which measurements are taken.
Fwd
Back
Left
Right
Up
Down
Layout results
Shows the layout difference in terms of line, height and offset based on the last distance and angle measurements.
60
Return to entry of layout values.
Measure distance and continue,
showing layout corrections.
Return to entry of layout values.
Show and save the result.
Measure distance and update
layout corrections.
Enter the next point.
The target must be moved further toward the reference
plane.
The target must be moved further away from the refer-
ence plane.
The target must be moved further to the left, as seen
from the tool, by the amount indicated.
The target must be moved further to the right, as seen
from the tool, by the amount indicated.
The target must be moved further up, as seen from the
tool, by the amount indicated.
The target must be moved further down, as seen from
the tool, by the amount indicated.