Installation instructions
Transportation and handling before installation
Transport the product as close to the installation location as
practical before unpacking.
·Handling Method
When handling the unit, ensure the unit is balance, check
that connection is secure, then lift up smoothly.
(1) Do not remove any packing materials.
(2) Hang the packaged unit with two ropes, as shown in
Fig. blow.
Installation locations selection
Before choosing the installation site, obtain user's approval.
·Where it is not exposed to strong wind.
·Where adequate air flow is possible.
·Where it is not exposed to rain and direct sunshine.
·Where neighbors are not disturbed by operation sound or hot air.
·Where rigid wall or support is available to prevent the increase of operation sound or vibration.
·Where there is no risk of combustible gas leakage.
·Where it is at least 10ft (3m) away from the antenna of TV set or radio. An amplifier may be required for the
affected device.
·Install the unit horizontally.
·Please install it in an area not affected by snowfall or blowing snow. In areas with heavy snow, please install a
canopy, a pedestal and/or some baffle boards.
CAUTION:
Avoid the following places for installation where air
conditioner trouble can occur.
·Where there is machine oil.
·Salty places such as seaside.
·Where sulfide gas is generated such as a hot spring.
·Where there is high-frequency or wireless equipment.
NOTE:
When operating the air conditioner in low outside temperature, be sure to follow the instruction described below.
·Never install the outdoor unit in a location where air inlet/outlet side may be exposed directly to wind.
·To prevent exposure to wind, install the outdoor unit with the air inlet side facing the wall.
·To prevent exposure to wind, it is recommended to install a wind baffle on the air outlet side of the outdoor unit.
·Handling
Make sure the product is protected by package, cloth, or
similar when it is being moved.
24K/36K: Over 12 in. (300mm)
48K/60K: Over 24 in. (600mm)
4
Put Cloth or Paper