Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Drainage elbow and condensate drain hose installation
Install drainage elbow and condensate drain hose
·The condensate water may drain from the outdoor unit
when the unit operates in heating mode. In order to In order
to enable reliable operation and protect the environment, it
is necessary to install a drainage elbow and a condensate
drain hose to drain the condensate water.
·Preform drainage work before indoor unit and outdoor unit
are installed and connected.
Connect the condensate drain hose [
·
diameter: 3/5" (15mm) ] as shown in the figure for drainage.
Outdoor unit installation
(1) Use washers when mounting the unit with bolts to the foundation.
(2) When fastening the outdoor unit with the foundation bolts. Reference Fig 1. for fastener hole locations.
(3) Fasten the outdoor unit as shown in Fig 2.
(4) Make sure to fasten the outdoor unit tight and horizontal to make sure the unit operates correctly.
(5) Make sure the condensate drain is routed away from places where it might do any harm.
(6) Use a robust base for the equipment (made of concrete, etc.) The equipment should be installed no less than
4" (10 cm) above grade level, to ensure proper drainage and operation. Failing to meet the installation requirements
may reduce equipment life cycle. reduce its life time. (Fig.3)
Model
A
B
33-7/8
12-3/16
24K
(860)
(310)
36K/48K
37-3/8
13-3/8
/60K
(950)
(340)
field-supplied nside
C
D
E
21-11/32
13-7/16
14-1/2
(542)
(341)
(368)
(168)
22-7/8
14-15/16
16-1/4
(580)
(380)
(414)
(185)
Fig.1
Drainage elbow
, i
NOTE:
Do not use the drainage elbow in the cold region. Drain
may freeze and stop the fan operation.
Cut it off, if the bolts is too
long, or it will be
troublesome of the moving
in the future.
[Unit: in. (mm)]
F
d
6-5/8
7/16*21/32
(11*17)
7-1/4
5/8
(15)
5
Drain hose
beton
anchor bolt
Fig.2
Setscrew
(at least 4)
Min. 4 in. (10cm)
Fig.3
Publicidad
