Dyna-Glo EG10000DH Instrucciones De Instalación Y Mantenimiento página 11

OPERATING INSTRUCTIONS
Check that the garage heaters outlet grill is not covered or obstructed in anyway, and
make sure the power to the unit is switched on.
The garage heater control functions can be accessed in two (2) ways:
• Using the touchpad control panel, located on the front of the garage heater below the
air guide plates.
• Using the multifunction remote control unit.
1. Main Power Button:
This button supplies power to all of the garage heaters functions. It must be turned on
for the garage heater to work
2. Heater Control Button:
This button adjusts the 3 heating stages: OFF Fa (Fan Only) LOW (7500W displays
"L"), High (10000W displays "H").
3. Temperature/Timer Display:
This LED display shows the set point for the temperature and timer functions. When
either of these functions is activated, the display reflects the set point for five seconds
and then fades to black. Any change to he set point of the temperature or timer will
reactivate the display, which again fades after five seconds.
4. DOWN Control Button:
This button is used to decrease temperature or timer settiing. It adjusts the
temperature range between 10°C - 35°C (50°F - 95°F) in 2°F (/1°C) increments.
5. UP Control Button:
This button is increasing temperature or timer setting. It adjusts the temperature range
between 10°C - 35°C (50°F - 95°F) in 2°F (/1°C) increments.
6. Timer Button:
This button controls the Timer ON/OFF and 8 settings from 1 hour to 8 hours. When
the Timer is first turned on, it will come on at the shortest time setting (1hour). Each
time the Timer button is pressed, the time increases by 1 hour, up to the longest
setting (8 hours). Once the set time expires, all garage heaters functions will be
automatically turn off.
7. Fahrenheit/Celsius Button:
REMOTE:
This button displays F (Fahrenheit) or C (Celsius) depending on how the temperature
mode is set. When the garage heater is turned on, the Fahrenheit (F) temperature will
be displayed.
GARAGE HEATER :
To switch from Fahrenheit to Celsius, or vise-versa, when the garage heater is ON,
hold HEATER CONTROL button for 5 seconds. Unless power to the unit has been
interrupted, the garage heater will remember the last temperature mode setting and
will start at that setting.
11