Dyna-Glo EG10000DH Instrucciones De Instalación Y Mantenimiento página 3

ITEM
SPECIFICATIONS ...........................................................................
SAFETY INFORMATION .................................................................
LOCATING HEATER .......................................................................
PRE-INSTALLATION .......................................................................
INSTALLATION ...............................................................................
OPERATING INSTRUCTIONS ........................................................
MAINTENANCE ..............................................................................
REPLACEMENT PARTS .................................................................
TROUBLESHOOTING ....................................................................
Rating
10000W II 240-1-60
7500W II 240-1-60
THIS HEATER REQUIRES HARDWIRE INSTALLATION (NO PLUG). THE INSTALLATION OF THIS
PRODUCT MUST BE CARRIED OUT BY A CERTIFIED ELECTRICIAN AND IN ACCORDANCE WITH
ALL LOCAL AND NATIONAL ELECTRICAL CODES.
NOTE: COMPATIBLE WITH SOME 240V LINE VOLTAGE DOUBLE POLE WALL THERMOSTATS.
MUST BE INSTALLED BY A CERTIFIED ELECTRICIAN.
READ AND UNDERSTAND ALL INSTALLATION & OPERATION INSTRUCTIONS PRIOR TO
OPERATING THIS UNIT. OBSERVE ALL SAFETY INSTRUCTIONS.
1. Use only copper wires rated for at least 60ºC.
2. Heater air flow must be directed parallel to or away from adjacent wall.
3. Observe all wall, floor and ceiling clearance requirements.
4. All wiring must be done according to national and local electrical codes. The
heater must be grounded as a precaution against possible electrical shock.
Heater circuit must be protected with proper fuses.
5. The mounting structure and the anchoring hardware must be capable of
supporting the weight of the heater and the mounting bracket (if used).
TABLE OF CONTENTS
SPECIFICATIONS
AMPS
41.66
31.25
SAFETY INFORMATION
WARNING
3
PAGE #
3
3
4
5
6
10
12
12
13
BTU/hour
34120
22589