LG WCEP6423 Serie Manual Del Propietário página 58

en-us_main.book.book Page 58 Friday, February 10, 2023 10:10 AM
58 MAINTENANCE
• Do not force the oven door open when the lock
is displayed. The oven door remains locked
k
until the oven temperature has cooled. Forcing
the door open will damage the door.
After the Self Clean Cycle
• The oven door remains locked until the oven
temperature has cooled.
• You may notice some white ash in the oven.
Wipe it off with a damp cloth or a soap-filled pad
after the oven cools. If the oven is not clean after
one self-clean cycle, repeat the cycle.
• If oven racks were left in the oven and do not
slide smoothly after a self-clean cycle, wipe racks
and rack supports with a small amount of
vegetable oil to make them glide more easily.
• Fine lines may appear in the porcelain because it
went through heating and cooling. This is
normal and will not affect performance.
Cleaning Scale on Lower Oven
Bottom
To remove mineral deposits that remain on the
oven bottom after using the steam mode, use a
cloth or sponge soaked in vinegar or a weak citric
acid solution. For more stubborn or extensive
scaling, use the Descaling function.
Descaling
Use this function to remove the white deposits
that form after the steam generator is used for a
long period.
The Descaling function runs for 1 hour 43 minutes.
Water will come out of the steam generator while
it is being cleaned.
For instructions on removing and filling the steam
feeder tank, see "Using the Steam Feeder Tank."
Setting Descaling
1
Fill the steam feeder tank with a 50:1 mixture
of water and citric acid. For example, use 4 tsp
of citric acid in 4 1/4 cups water (20 g citric
acid in 1000 ml water).
2
Insert the steam feeder tank into the slot over
the upper oven cavity and push it in until it
clicks into place.
3
Press More Modes and press 5. Press START.
4
After 1 hour 43 minutes of descaling, a popup
will appear in the display. Following the
instructions, drain the tank and fill it with
clean water.
5
Insert the tank and start the Rinsing function.
6
Once the Rinsing function is complete, dry the
inside of the oven with a soft cloth. Leave the
oven door open and allow the oven to dry
completely.
NOTE
• The Rinsing function must be completed even if
the Descaling function is canceled.
• If water remains on the oven bottom after
descaling, it can leave a residue after the oven is
used. To remove the residue, see the
instructions under "Cleaning Scale on Oven
Bottom."
• After running the Descaling function, clean the
steam feeder tank.
Periodic Maintenance
Changing the Oven Light
The oven light is a standard 25-watt halogen bulb
for ovens.
WARNING
• Make sure that the oven and bulb are cool.
• Disconnect the electrical power to the appliance
at the main fuse or circuit breaker panel. Failure
to do so can result in severe personal injury,
death, or electrical shock.
• Wear gloves while changing the oven light. Glass
fragments from broken bulbs can cause risk of
injury.
• Gently twist the screwdriver blade while
changing the oven light. If you apply force, the
glass or oven may crack.
1
Unplug the oven or disconnect power.
2
Remove the oven racks.