Publicidad
2
OPERATIONAL SAFETY
READ BEFORE BEGINNING ASSEMBLY.
FAILURE TO UNDERSTAND AND FOLLOW ALL SAFETY RULES AND ASSEMBLY INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DEATH.
METAL CONDUCTS ELECTRICITY:
Do not use this equipment where contact may be made with power lines or other live electrical circuits.
DO NOT OVERLOAD:
This scaffolding is designed to support a maximum load of 500 lb (227 kg).
Storage rack: 200 lb (90.7 kg) distributed weight
OPERATION AND SAFETY
Do not use this equipment if you are in poor health, taking medications, drugs, or have
been consuming alcohol, all of which may impair your ability to work safely on this product.
Always use this scaffold in conformity with local or national legislation which applies.
Inspect before use. Do not use scaffold if damaged or parts are missing.
Examine thoroughly to make sure unit is properly set up.
Always use casters locked to the side frames with the locking pins.
Securely lock all braces and deck before each use.
The deck must be fully seated within the braces.
The wood deck must be checked for loose or missing steel frame components, large holes
or thin spots where the plywood has been worn. Worn or damaged deck must be replaced
promptly.
Braces must be inspected to ensure locking mechanisms are working correctly. Any
brace with damaged locking devices should not be used.
Never sit, stand or climb on the shelf.
Check that the shelf wires are well inserted in the holes of each brace.
When used as a storage rack, this scaffolding must be secured by the anti-tip assembly
supplied.
Install the anti-tip assembly under the highest rung of the scaffold.
For your own safety, read and understand the miter saw instruction manual before using
the universal miter saw stand.
Always fasten the miter saw to the mounting brackets as instructed.
Always lock the mounting brackets in place before using the miter saw.
Piece supports must be locked with the tightening knobs.
There must be a minimum of two side braces installed on each scaffold level and evenly
spaced throughout the scaffold. Lack of adequate bracing could cause scaffold to collapse.
Do not climb unless all casters are in locked position.
Always remove casters when using this scaffolding on stairs.
Always climb up or down the scaffolding side frames facing towards the ladder.
Always keep the body centered between the side frame's uprights.
ALWAYS INSPECT
BEFORE USE
METAL CONDUCTS
ELECTRICTY
UNIT SHALL ONLY
BE USED ON
FIRM AND LEVEL
SURFACES
NEVER PLACE
ANYTHING UNDER
OR ATTACH
ANYTHING TO UNIT
All photos and drawings in this booklet are for reference purposes only. Refer to applicable OSHA, ANSI or CSA codes and regulations for the proper use of this equipment.
Always keep three points of contact with the ladder.
When climbing from the exterior, always step over the ladder to access the platform.
Always keep a steady pace when climbing.
Do not create a swaying motion when climbing.
Erect to be plumb on firm and level surface.
This scaffold must be used on a firm surface that is free of pits, debris, holes or
obstructions.
Never place anything under or attach anything to this scaffold to increase height or to
adjust to uneven surfaces.
Acids are corrosive and can seriously affect strength. Do not expose this scaffold to
corrosive substances.
This product is designed to be used and stored indoors. The use or the exterior storage
could result in structural deterioration due to rust and damaged or can lead to rotting wood
framing. Store dry.
Keep scaffold free of debris and unnecessary equipment.
Keep your body close to the scaffold as you climb.
Do not overreach. Always keep body centered inside structure of scaffold.
Remove or fasten all tools, material or equipment before moving. Use extra caution when
moving to avoid tipping.
Never try moving this scaffold while standing on it.
Never move a scaffold with a worker within.
Do not use powered devices to propel this scaffold. Use extra caution near operating
machinery.
Do not use if the surface is not firm and level.
Do not use in inclement weather or high winds.
Maintain a firm grip while climbing.
Do not modify the scaffold or any of its components.
Do not use the scaffold as a footbridge.
ALWAYS LOCK ALL
THE CASTERS
BEFORE CLIMBING
ALWAYS KEEP BODY
CENTERED INSIDE
STRUCTURE OF UNIT
NEVER TRY MOVING
THE UNIT WHILE
STANDING ON IT
REMOVE OR FASTEN TOOLS,
MATERIAL OR EQUIPMENT
BEFORE MOVING. NEVER
MOVE A SCAFFOLD WITH
WORKER WITHIN.
SCAFFOLD
MAX
MAXIMUM LOAD
CAPACITY: 500 lb
MAX. 500 lb
(227 kg)
(227 kg)
DO NOT USE IN
INCLEMENT
WEATHER
OR HIGH WINDS
ERECT ON FIRM
AND LEVEL GROUND
DO NOT USE
THE UNIT AS
A FOOTBRIDGE
ALWAYS CLIMB
UP OR DOWN THE
SCAFFOLDING SIDE
FRAMES FACING
TOWARDS THE
LADDER.
DO NOT CREATE A
SWAYING MOTION
WHEN CLIMBING.
ACIDS ARE
CORROSIVE.
DO NOT EXPOSE
UNIT TO CORROSIVE
SUBSTANCES
Publicidad
