Publicidad
Idiomas disponibles
Idiomas disponibles
Extra water
Chemical solution
Start
Preparation and Check – Spraying
・When starting, perform test run with fresh water to
make sure that the power sprayer is not faulty.
CAUTION
If the power sprayer is faulty, stop it immediately.
See Troubleshooting and Actions for Power Sprayer
on Pages 18 and 19.
・When putting the hose in the chemical tank, set the
Water intake
water intake pump head within 3 meters.
CAUTION
Moving of the water intake hose and extra water
hose is dangerous, so fasten them with the attached
band securely.
・Make sure that the strainer is securely in the water
source.
・As shown in the figure, move the pressure control
Handle
valve handle up to the "Start" position.
・Align the "0" scale on the grip with the pressure
indicator position.
CAUTION
Grip
Note that starting in the pressurized state may
damage the piston packing because water intake
cannot be performed and idling occurs.
・Close the discharge ball valve.
CAUTION
If water intake is started without the valve closed,
the conditioner may suddenly come out of the valve
or nozzle may move fast. Be sure to close the valve.
13
Publicidad
