Descargar Imprimir esta página

KINTERA KB900SS Manual Del Usuario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
1.- LOCATION OF ICE MACHINE
This ice maker is not designed for outdoor operation. The icemaker should not be located next to ovens, grills or other high heat
producing equipment.
The machines are designed to operate at room temperature between 41ºF (5ºC) and 109.4ºF (43ºC). There may be some
difficulties in ice slab removal under the minimum temperatures. Above the maximum temperature, the life of the compressor is
shortened, and the production is substantially lower.
The air cooled (undercounter) ice makers take the air through the front section, and drive it off through the back and front louvers
due to their new oblique condenser structure and placement. Do not place anything on the top of ice maker or facing the front
grille. In case the front grille is either total or partially obstructed, or due to its placement it receives hot air from another device, we
recommend, in case it is not possible to change the location, to install a water-cooled machine.
The air cooled (modular) ice makers take the air through the back section and drive it off through the two lateral louvers. In the
case it is not possible to respect the minimum distances recommended (see the picture in point 3) for these machines we
recommend installing a water-cooled unit.
The location must allow enough clearance for water, drain and electrical connections in the rear of the ice machine. It is important
that the water inlet piping do not pass near sources of heat so as not to lose ice production.
2.- LEVELING THE ICE MACHINE
Use a level on top of ice machine in order to ensure the equipment is perfectly levelled.
Only for (undercounter) machines:
Screw the levelling legs onto the bottom of the ice machine as far as possible.
Move the machine into its final position.
Use a level on top of the ice machine. Turn each foot as necessary to level the ice machine from front to back and side to side.
NOTE: An optional 3 1/2'' (90mm) caster assembly is available for use in place of the legs. Installation instructions are supplied with
the casters.
5

Publicidad

loading

Este manual también es adecuado para:

Kuf360-1aKhm1000-2a1p