Hilti DGH 130-22 Manual De Instrucciones Original página 34

come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
The battery runs down more
quickly than usual.
The battery doesn't engage
with an audible click.
The product or battery gets
very hot.
Product does not develop full
power.
The motor has no braking
effect.
Product vibrates severely.
LEDs of the battery show
nothing
28 English
Possible cause
Very low ambient temperature.
The retaining lug on the battery is
dirty.
Electrical fault
A battery with inadequate capacity
was used.
Battery is discharged.
Product is momentarily
overloaded.
Accessory tool is not compatible
with the product.
Accessory tool is damaged, out of
true or imbalanced.
Product faulty
Battery faulty.
Action to be taken
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lug and
re-insert the battery.
▶ Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact Hilti
Service.
▶ Use a battery with adequate
capacity.
▶ Change the battery and charge
the empty battery.
▶ Switch the product off and then
on again.
▶ Use only accessory tools that
comply with the specifications
in the technical data.
▶ Use only accessory tools that
are in faultless condition.
▶ If the accessory tool can be
ruled out as the cause, consult
Hilti Service.
▶ Contact Hilti Service.
2359096
*2359096*