▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 12
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3
Description
3.1
Product overview
3.2
Intended use
The product described is a cordless diamond grinder for dry-grinding, fine-grinding and polishing mineral
materials. Use the diamond grinder only in combination with a dust extractor.
For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
•
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
•
For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3
Items supplied
Grinder, diamond cup wheel, pad holder for finishing pad (DLX only), diamond finishing pad (DLX only),
operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
*2359097*
1
2359097
Gripping surface
@
Spindle lock button
;
On/off switch
=
Grip
%
Buttons for speed stages
&
Adjusting lever for segment opening
(
Guard
)
Battery release button
+
Battery status indicator
§
Battery
/
Pad holder for finishing pad (DLX only)
:
Finishing pad for finishing (DLX only)
∙
Installation opening
$
Sealing lip
£
Spindle
|
Clamping flange
¡
Diamond cup wheel
Q
Quick-release lock nut
W
Height adjustment of the guard
E
Connector for dust extraction
R
English
7