Pur Line NTW-25 Manual De Instrucciones página 14

EN
1. Drill 4 holes of φ8 as shown dimensions in Fig. 1.
2. Put 4 expand tubes into the holes, and then fix the 4 "outer fixtures" on the wall with the ST4x40 screws (Fig. 2).
3. Fix the 4 "inner fixtures" and 4 "front fixtures" on the appliance with the ST3.5x20 screws (Fig. 3).
4. Put the "inner fixtures" of the appliance into the "outer fixtures" of the wall, adjust the right distance between
the appliance and the wall, then fix them with the M5x14 screws (Fig. 3).
5. Cover the "front fixtures" with the 4 caps (Fig. 3).
OPERATION
Plug into any 230V, 50Hz, AC source. Turn on the switch at side, and the evice emits a "Di" sound.
Press the power to start the heater, the LED displays room temperature, then use touch control to set
power, temperature and time.
3
The touch screen buttons on the product correspond to
the remote control functions:
1. display
1
2. temperature
3. mode
4
2
4. timer
5. power
5
Power
When the product is on, press "power", . the upper part of the display shows temperature.
The heater is working at low power heating conditions.
Mode
Press "mode" to regulate low , or high temperature power.
Temperature
Press temperature button , the temperature can be set from 16°C to 40°C.
Internal temperature is displayed every time the appliance is started up. The temperature can be set when the
appliance is in stand-by or heating. When the room temperature reaches the set level, the high temperature
power stops and the low temperature power remains active. When room temperature is 2 degrees over the
set temperature, both the high and lower temperature powers will stop operating. The machine will begin
operating again only when temperature decreases 2 degrees with respect to the set temperature.
Timer
The timer button can be set to start or stop the appliance at the desired time, with a
time interval between 1 hour and 24 hours.
Child Lock (remote control)
Press the Child Lock button for 3 seconds, the device is locked and can be turned on.
After pressing the button for 3 seconds again, the device is unlocked.
When there is no remote control, you can press the button on the device for 5
seconds to lock or unlock the display.
12