Kuppersbusch DW 3800.0 S Instrucciones De Uso página 12

Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in the
diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure
that a steady air flow has been established
before fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking
(between 3 to 5 minutes) in order to expel all
the grease from the outlet duct. This prevents
the return of grease, smoke and smells.
Setting The Extraction Time
•Turn the hood on and select the required
extraction speed
•Select the programming time by pressing
Timer.
•Each press of the button increases the
programming time by 10 minutes, up to a
maximum of 80 minutes.
•To reset the programme, wait for over a
second and press the Timer button again.
•The speed and extraction time are displayed
with the LED indicator.
•The intensive speeds 6, 7 and 8 cannot
be programmed. These must be selected
manually and have a maximum duration of
approximately 10 minutes.
Filter Saturation "F"
•Clean the filters when all lights of the LED
indicator begin to flash followed by an
acoustic signal.
•Press "Filter Saturation" to reset this feature
Cleaning and maintenance
During cleaning and maintenance
work, make sure the safety instructions
are complied with.
Cleaning the hood body
•If your kitchen hood is made of stainless
steel, use proprietary cleaners mentioned in
the product instructions.
•If your kitchen hood is painted, use lukewarm
water and a neutral soap.
•Never use metallic scourers, nor abrasive or
corrosive products.
•Dry the kitchen hood using a cloth that does
not produce fibres.
•Do not use vapour cleaners.
Cleaning the metal filters
•To remove the filters from their fittings, press
lightly on the locks and then pull them off.
•The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher.
In this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
•Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
•Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Changing light bulbs
For changing the light bulbs please contact
the manufacturer's nearest Technical
Service.