Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1. Push the tabs (13) on the sides of the trimmer head at the
same time.
13
2. Pull and remove the spool cover (14).
3. Remove any remaining line.
4. Clean dirt and debris from all parts. Replace spool (15) or
spool cap (14) if it is worn or damaged.
5. Align the spool tabs with the tab openings in the base of
the spool.
6. Push the spool cover until it clicks into position.
10.4
INSTALL THE CUTTING LINE
Do not put more than 26-ft of .095" line at a time.
1. Remove the remaining cutting line on the spool.
14
15
NOTE
English
2. Line up the slot (16) on the spool cap with the line exit
hole (17) on the trimmer head.
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap clockwise to wind the cutting line into
the trimmer head. Keep approximately 5 in of cutting line
above out of each side of the trimmer head.
12
16
17
Publicidad
