Features; Product Specifications; Assembly; Auxiliary Handle Assembly - Ryobi D620H Manual Del Operador

PRODUCT SPECIFICATIONS

Chuck Capacity ......................................................... 1/2 in.
Drilling Capacity:
Concrete ................................................................ 5/8 in.
Metal ...................................................................... 1/2 in.
UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.

FEATURES

Switch .............................. Variable Speed Reversible (VSR)
Blows Per Minute ........................................0 – 43,000 BPM
No Load Speed .................................0 – 2,700 r/min. (RPM)
Input ................................ 120 V, AC only, 60 Hz, 6.2 Amps

ASSEMBLY

AUXILIARY HANDLE ASSEMBLY

See Figure 1, page 11.
WARNING:
Always use the auxiliary handle when using this tool to
help resist torque reactions. Binding or stalling of this
product could lead to serious personal injury.
The drill is equipped with an auxiliary handle assembly. For
ease of operation, use the handle with either the left or right
hand. The handle can be rotated 360°.
 Loosen the handle assembly by turning the handle coun-
terclockwise.
 Slide the auxiliary handle assembly onto the hammer drill
in the desired operating position.
NOTE: Make sure the notches on the inside of the auxiliary
handle engage the tabs on the drill housing.
 Securely tighten by turning the auxiliary handle clockwise.
NOTE: Be sure the auxiliary handle is securely tightened
against the depth stop rod clamp. This secures the depth
stop rod at the desired depth of cut. It also secures the
auxiliary handle.
INSTALLING THE CHUCK KEY STRAP
See Figure 2, page 11.
Use the chuck key strap to store the chuck key when not
in use.
To install:
 Form a loop by forcing the end of the strap with the round
holes through the slot on the opposite end.
 Place the loop over the cord and pull it tight.
 Mount the chuck key by inserting the geared end through
the hole in the holder. Large keys fit in the larger hole;
smaller keys fit in the small hole.
6 — English