Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING AND MAINTENANCE
Do not use steam cleaning
equipment.
Use protective gloves during all
operations.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of
cooking foods with a high water content, allow the
oven to cool completely and then wipe it with a cloth
or sponge.
REMOVING AND REFITTING THE DOOR
1. To remove the door, open it fully and lower the
catches until they are in the unlock position.
2. Close the door as much as you can.
Take a firm hold of the door with both hands – do not
hold it by the handle.
Simply remove the door by continuing to close it
while pulling it upwards (a) at the same time until it is
released from its seating (b).
~60°
Put the door to one side, resting it on a soft surface.
3. Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their
seating and securing the upper part onto its
seating.
4. Lower the door and then open it fully.
Lower the catches into their original position:
Make sure that you lower them down completely.
5. Try closing the door and check to make sure that
it lines up with the control panel. If it does not,
repeat the steps above.
Carry out the required
operations with the oven cold.
Disconnect the appliance from
the power supply.
• Activate the "Steam Cleaning" function for optimum
cleaning of the internal surfaces.
• The door can be easily removed and refitted to
facilitate cleaning of the glass.
• Clean the glass in the door with a suitable liquid
detergent.
• The top heating element of the grill can be lowered
to clean the upper panel of the oven .
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
PRESS TO CLEAN CLEANING THE GLASS
1. After removing the door and resting it on
2. Lift and firmly hold the inner glass with both
3. To correctly reposition the inner glass, make sure
~15°
b
a
4. Refit the upper edge: a click will indicate correct
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
a soft surface with the handle downwards,
simultaneously press the two retaining clips and
remove the upper edge of the door by pulling it
towards you.
hands, remove it and place it on a soft surface
before cleaning it.
that the "R" is visible in the left-hand corner. First
insert the long side of the glass indicated by "R"
into the support seats, then lower it into position.
positioning. Make sure the seal is secure before
refitting the door.
EN
9
Publicidad
