8 TIPS FOR SAVING ENERGY
1. Install the appliance in a cool, well-
ventilated room, but not in direct sunlight
and not near a heat source (such as a
radiator or oven) otherwise an insulating
plate should be used.
2. Allow warm food and drinks to cool
before placing them inside the appliance.
3. Place thawing food in the refrigerator
compartment. The low temperature
of the frozen food will help cool the
refrigerator compartment while the food
is thawing. This will save energy. Frozen
food left to thaw outside of the appliance
will result in a waste of energy.
4. Drinks or other liquids should be
covered when inside the appliance. If
left uncovered, the humidity inside the
appliance will increase, therefore the
appliance uses more energy. Keeping
drinks and other liquids covered helps
preserve their smell and taste.
5. Avoid keeping the doors open for long
periods and opening the doors too
frequently as warm air will enter the
appliance and cause the compressor to
switch on unnecessarily often.
6. Keep the covers of the different
temperature compartments (such as the
crisper and chiller) closed.
7. The door gasket must be clean and
pliable.
In case of wear, replace the
gasket.
8. Energy consumption of your appliance
is declared without drawers and fully
loaded in freezer compartment.
9. For saving energy, do not use volume
between the load limit and the door,
along the load limit line. Load limit line
is also used in energy consumption
declaration.
EN - 71