Publicidad
Idiomas disponibles
Idiomas disponibles
3. Select a suitable attachment. Insert this attachment into the
opening of the insert holder. Tighten the attachment onto
the drive shaft clockwise.
•
dark green insert for chopping coarsely
•
light-green insert for chopping finely
•
yellow insert for grating
•
orange insert for rasping finely
•
red insert for rasping coarsely
4. Place a bowl under the insert holder to collect the cut or
grated food.
5. Remove the peel from the food if necessary. The peel
could clog the insert holder.
6. Chop up large pieces of food to be able to fill them into the
insert holder without a problem.
NOTE about the selection of the insert:
If the result of the chopping should not be satisfactory, try it
with a different insert. Attach a rasp instead of the grater, for
example.
Disassembly
1. Release the insert from the insert holder by twisting it anti-
clockwise and lightly lifting it. Use the supplied tool, if
necessary.
2. Release the insert holder from the motor block by turning it
clockwise.
Electric operation
1. Before you plug the mains plug into the outlet, check
whether the system voltage that you want to use, matches
the one of the appliance. You will find information about it
on the type plate.
2. Connect the appliance to a correctly installed grounded
outlet.
Turning on/off
•
You can turn the appliance on with the switch (10).
•
The appliance will turn off when you release the switch.
CAUTION: Short-term operation
Do not use the appliance continuously for more than 5 min-
utes. Allow to cool down for approx. 1 minute before using it
again.
Operation
NOTE:
Peel the food, if necessary chop large pieces.
1. Fit the desired insert.
2. Connect the appliance to a properly installed isolated
ground receptacle.
3. Fill the food into the feed neck.
4. Keep the switch pressed with one hand to turn on the appli-
ance.
5. Press the food down with the pusher. Pay attention to the
flattened side of the pusher.
WARNING:
Always use the supplied pusher. Never put your fingers or
tools into the feed neck!
Ending operation
Disconnect the plug from the outlet.
Cleaning
WARNING:
•
Always remove the power cord before cleaning.
•
Never immerse the motor block in water. It could result in
an electric shock or fire.
•
The cutting surfaces of the inserts are sharp. Injury may
occur! Always touch the inserts on the plastic.
CAUTION:
•
Do not use a wire brush or other abrasive utensils for
cleaning.
•
Do not use aggressive or abrasive cleaning agents.
NOTE:
Color residues from vegetables (e.g. carrots) are best
removed with a cloth and cooking oil.
Immediately clean the appliance after each use.
Accessories
1. Remove the insert from the insert holder.
2. Twist off the insert holder from the motor block. Remove
the pusher.
3. You may rinse the accessories in a bowl of hot water and
then dry them.
Housing
1. Clean the housing with a moist towel.
2. Remove any residual water with a dry cloth.
Noise Emission
The sound pressure level was measured at the operator's ear
(LpA) in accordance with DIN EN ISO 3744.
Determined sound pressure level: 79.0 – 82.3 dB(A) (no limit)
Technical Specifications
Model: ........................................................................ME 466 CB
Power supply: ............................................220-240 V~, 50/60 Hz
Power consumption: .......................................................... 150 W
Protection class: ......................................................................... II
Short term operation: ....................................................5 minutes
Net weight: .......................................................... approx. 1.35 kg
The right to make technical and design modifications in the
course of continuous product development remains reserved.
27
Publicidad
