Publicidad
Idiomas disponibles
Idiomas disponibles
IL51862623
ITEMS REQUIRED
(Purchase separately)
1. Philips Screwdriver
2. Safety Goggles
3. Adjustable Wrench
4. Work Gloves
5. Ladder
6. Power Drill
SPECIFICATIONS
MOTION SENSOR
SENSING
RANGE
ANGLE
25FT
120°
PREPARING FOR INSTALLATION
REVIEW THIS INFORMATION TO ENSURE A REVIEW CONTENTS
Before installing the light fixture, take the contents out of the packaging and ensure that all parts are present. Compare parts with the hardware
included and package contents sections. Do not attempt to assemble, install, or operate this light fixture if any part is missing or damaged.
ESTIMATED INSTALLATION TIME: 30 MINUTES
CHECK THE INITIAL BATTERY CHARGE
1. Prior to use, make sure batteries have been charged for 2 full days of sunlight. (The battery will require 8 to 12 hours of full, direct sunlight to
completely charge.) Ensure the fixture is OFF by selecting that button on the included remote. If possible aim the solar panel located on the
back of the fixture toward the South and tilt it approximately 50 degrees from horizontal.
2. Check the battery indicator light located in the fixture lens before install (see table below)
3. Actual operating time will vary depending upon how frequently the light is turned on by the motion sensor
4. Solar lighting is not designed to equal standard 120V lighting. The amount of light output is reduced to allow the sun time to fully recharge the
battery between lighting cycles.
5. Solar collection is only effective in direct sunlight. Every hour the light is on requires a minimum of 5 hours of sunlight charging.
MOTION SENSOR
1. When deciding where to mount this fixture please keep in mind that the motion sensor that activates the light has a "field of vision" of 25ft in
front of the light and about 120-degree detection angle at a surrounding air temperature of 77F.
2. The motion sensor will have a first-time use warm-up time of about 60 seconds. Please wait a minimum of 60 seconds after the first power-on
before testing the motion sensor.
3. When testing the motion sensor performance during the daytime the solar panel will need to be covered to override the Dusk to Dawn
functionality of the light fixture. Cover the solar panel fully using a piece of cardboard and tape for first time testing.
LED
BATTERY
INDICATOR
MOTION
LIGHT
SENSOR
2
1
2
LUMENS
POWER SPECIFICATIONS
1000lm
Solar Panel and Rechargeable Nickel
Manganese Cobalt Batteries (non-
OR
replaceable)
1500lm
Battery Lifespan: 500 Cycle
OR
3000lm
LED BATTERY INDICATOR GUIDE
FIXTURE STATUS
Charging in progress
ON/OFF
(battery from 10% to 90%)
SWITCH
Charging completed
(Battery > 90%)
Discharging in progress
(battery from 90% to 10%)
Battery low (<10%)
Motion mode selected
D2D mode selected
Motion + D2D
Modeselected
Solar LED Dusk to Dawn & Motion Activated Area Light Instructions
3
4
5
OPERATING MODE
Motion, Dusk to
Dawn, Motion
+Dusk to Dawn,
Manual On, Manual
Off
RED LED
OFF
OFF
OFF
ON
Remains in the
same state
Remains in the
same state
Remains in the
same state
ENGLISH
6
MOTION SENSOR
TIME OUT SETTING
30 seconds,
60 seconds,
90 seconds
GREEN LED
FIXTURE LED
Blinking
OFF
ON
Remains in the same
state
OFF
Remains in the same
state
OFF
Remains in the same
state
Remains in the
Blinks once when
same state
mode selected
Remains in the
Blinks 2 times when
same state
mode selected
Remains in the
Blinks 3 times when
same state
mode is selected
www.cooperlighting.com
Publicidad
