Makita 3706 Manual De Instrucciones página 6

NOTE:
• When using this tool, the rotating action causes
the tool to pull. The less pressure applied to the
tool causes less pull and provides a more accu-
rate cut. Excessive pressure or fast cutting can
cause the bit to dull or break premature.
• When cutting drywall around outlet boxes, cut in
a counterclockwise direction for ease of cut.
• The standard bit included with this tool is for cut-
ting drywall only. When cutting materials other
than drywall, do not use the standard drywall
guide bit.
Circular guide
Circular cutting diameters: 10 cm (4") - 34 cm (13-3/8")
Installing circular guide
2
1
► 1. Shoe 2. Loosen 3. Tighten 4. Thumb screw
Release the thumb screw which serves to secure the
shoe.
Align the projections in the circular guide with the
grooves in the shoe, and secure the shoe and circular
guide using the thumb screw.
1
► 1. Shoe 2. Circular guide 3. Projections
3
4
2
3
To adjust the cutting depth, proceed first by loosening
the thumb screw and then by sliding the shoe and circu-
lar guide together. After completion of the adjustment,
tighten the thumb screw securely.
1
► 1. Shoe 2. Circular guide 3. Thumb screw
OPERATION
2
► 1. Knob 2. Tighten 3. Loosen
Loosen the knob, and adjust its position in accordance
with the size of the circle to be cut. (The hole dimen-
sions to be cut are indicated on the side of the circular
guide as a general guideline.) After completion of the
adjustment, tighten the knob securely.
Insert the end of the knob into the center of the circle to
be cut, and proceed to cut in a clockwise direction.
1
► 1. Knob
6 ENGLISH
2
3
1
3