Descargar Imprimir esta página

De Dietrich LK6GVX1A Guía De Utilización página 34

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 103
3
USE
3.1 CHOICE OF COOKWARE
Most cookware is compatible with induction. Only
glass, terracotta, aluminium without a special base,
copper and some non-magnetic stainless steels do
not work with induction cooking.
We suggest that you choose cookware with
a thick, flat bottom. The heat will be distributed
better and cooking will be more uniform. Never
leave an empty pan to heat unattended.
Avoid putting cookware on the control panel.
3.2 COOKING ZONE SELECTION
There are several cooking zones available. Select
one which is suitable, based on the size of the
pan. If the base of the cookware is too small, the
power indicator will start to flash and the cooking
zone will not work, even if the cookware's material
is recommended for induction. Take care not to
use pans which are smaller in diameter than the
cooking zone (see table)
Diameter of
Max. power of
cooking zone
cooking zon
(cm)
16
18
23
28
Horizone
1/2 zone
When several cooking zones are used at
the same time, the hob manages the power
distribution, so as not to exceed its total
power.
When you use maximum power (Boost) on
several cooking zones at the same time,
position pans to achieve the best positioning
and avoid arrangements .
Diameter of bot-
tom of cookware
(Watts)
(cm)
2400
10 - 18
2800
11 - 22
3700
12 - 24
3700
15 - 32
3700
18 - Ovale -
poisonnière
2800
11 - 22
3.3 SWITCHING ON/OFF
Press the On/Off key
zone for 8 seconds.
If no pan is detected, select a zoner.
If a pan is detected, the «0» flashes with a
dot. You can then set the power level. The
cooking area heats up automatically.
Switching off a zone on the hob
Press and hold the key for zone
beep sounds and the display goes off or an
«H» appears (residual heat).
Press the On/Off key
off completely.
3.4 SETTING THE POWER
Press the + or –
level between 1 and 19 or 1.
When switching on, you can go directly
to maximum power (apart from boost) by
pressing the «–» key for the zone.
Power presets
There are four
provide direct access to pre-set power
levels:
13
13
. «0» flashes in each
c
, a long
to switch the hob
g
key to adjust your power
f
keys available that

Publicidad

loading