Urmet elekta steel 1060/23 Manual De Usuario página 19

4 CALL USING THE TOPOLOGICAL CODE
The home page of the call module is shown here by the side.
The option ''FOR SWITCHBOARD PRESS
depending on the system confi guration.
For icon see chapter 7.
The icon
Enter the topological code of the apartment station to be called, using the
alphanumerical keypad, then press the
As an alternative, follow the instructions below.
?
Press the key to insert the topological code of the apartment station to be
called, editing the "Build", "Stair", "Floor", "Apt" fi elds using the alphanumerical
keypad, then press the
Conversations and busy conditions are managed in the same way as in calls by means of codes.
Refer to the respective section for more information.
5 CALL USING THE BLOCK SELECTION CODE
If the system was confi gured with this option, the home page call module is
shown here by the side.
The option ''FOR SWITCHBOARD PRESS
depending on the system confi guration.
DS1060-169
shows the next screen.
key to make the call.
" may not be present,
key to make the call.
" may not be present,
19