Publicidad
Idiomas disponibles
Idiomas disponibles
TABLE/DESK TOP INSTALLATION
CAUTION: Disconnect the telephone line cord
before connecting or disconnecting the battery
backup in the wall mount bracket.
1. Plug one end of the supplied modular telephone
line cord into the jack marked TEL located on
the back of the telephone base as shown in
the diagram.
9V DC
TEL
400 mA
2. Plug the modular telephone line cord's other
USE ONLY WITH CLASS
end into a modular phone jack.
(CLASSE) 2 POWER SOURCE
3. Insert the supplied AC Adapter's plug into the
jack marked 9V DC 400mA located on the
back of the telephone base.
4. Plug the adapter into a standard 120V AC
power (electrical) outlet.
5. Align the mounting bracket on the back of the
Connecting telephone
base so that the black rubber feet are towards
line cord
the bottom of the phone. Insert the bracket's
tabs into the slots and secure the bracket by
sliding it upward.
6. Lift the base's antenna to a vertical position.
7. Set the TONE/PULSE switch located on the
back of the base to correct dialing mode.
Please check with your local Phone Company
if uncertain of the type of service.
8. Place handset in the cradle to begin
initial charging.
9V DC
TEL
400 mA
WALL MOUNTING INSTALLATION
USE ONLY WITH CLASS
(CLASSE) 2 POWER SOURCE
CAUTION: Disconnect the telephone line cord
before connecting or disconnecting the battery
backup in the wall mount bracket.
The base unit may be mounted on a standard
wall plate.
1. Plug one end of the supplied short modular
Connecting AC
telephone line cord into the TEL jack located
Adapter
on the back of the base of the phone.
10
All manuals and user guides at all-guides.com
2. Insert the plug of the AC adapter into the jack marked DC 9V 400mA
located on the back of the telephone base.
3. Align the mounting bracket on the back of the base so that the black rub-
ber feet are towards the bottom of the phone. Insert the bracket's tabs
into the slots and secure the bracket by sliding it upward.
4. Plug the short modular telephone line cord into the wall plate jack, then
align the mounting bracket's keyhole slots with the wall plate studs and
slide the base of the phone downward to secure it on the wall.
5. Plug the adapter into a standard AC power (electrical) outlet.
6. Press and lift out the handset holder tab, turn it around so the narrow tab
end extends out and slide back into its slot.This will hold the handset in
the cradle when the phone is wall mounted.
7. Lift the base's antenna to a vertical position.
8. Set the Tone/Pulse switch located on the end of the base to correct dialing
mode. Please check with your local Phone Company if uncertain of the
type of service.
9. Place handset in the cradle to begin initial charging.
Note: Remember, you must charge the phone for at least 12 hours before you
use the phone for the first time.
11
Publicidad
