Sauder Steel River Serie Instrucciones De Montaje página 10

Step 4
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the EXTENSION BLOCKS (G). Use twelve 1/2" FLAT HEAD SCREWS (23) through
the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the EXTENSION BLOCK. Turn
a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
1/2" FLAT HEAD SCREW
(12 used in this step)
1
1
st
Page 10
23
Slide the black lever in and pull the SLIDE from the RAIL.
Open end
1
1
G
B
G
www.sauder.com/service
hole shown in the enlarged diagram. Then, slide the inner
st
2
1
G
C
Open end
7
Open end
1
G
427549