Bosch 0603B01200 Manual Original página 31

OBJ_BUCH-880-001.book Page 30 Tuesday, March 24, 2009 4:39 PM
30 | English
Adjusting Vertical Bevel Angles
(see figure H)
The vertical bevel angle can be set in the range
from 0° to 45°.
– Loosen the clamping lever 23.
– Tilt the tool arm by the handle 1 until the an-
gle indicator 36 indicates the desired bevel
angle.
– Hold the tool arm in this position and retight-
en the clamping handle 23.
For quick and precise setting of the standard
angles 0° und 45°, end stops are provided on
the housing.
– Loosen the clamping lever 23.
– For this, tilt the tool arm by the handle 1 to
the stop toward the right (0°) or to the stop
toward the left (45°).
– Retighten the clamping lever 23 again.
Starting Operation
Switching On
– To start the machine, press the On/Off
switch 19 and keep it pressed.
Note: For safety reasons, the On/Off switch 19
cannot be locked; it must remain pressed during
the entire operation.
The tool arm can only be guided downward
when pressing lever 3.
– For sawing, you must additionally press lever
3 in addition to actuating the On/Off switch.
(see figure I)
Switching Off
– To switch off the machine, release the
On/Off switch 19.
1 609 929 S46 | (24.3.09)
Working Advice
General Sawing Instructions
For all cuts, it must first be ensured that the
saw blade at no time can come in contact
with the fence, screw clamps or other ma-
chine parts. Remove possibly mounted aux-
iliary stops or adjust them accordingly.
Protect the saw blade against impact and shock.
Do not subject the saw blade to lateral pressure.
Do not saw warped/bent workpieces. The work-
piece must always have a straight edge to face
against the fence.
Long workpieces must be underlaid or support-
ed at their free end.
Marking the Cutting Line
(see figure J)
A laser beam indicates the cutting line of the
saw blade. This allows for exact positioning of
the workpiece for sawing, without having to
open the retracting blade guard.
– For this, switch the laser beam on with the
switch 20.
– Align the cutting mark on your workpiece
with reference to the right-hand edge of the
laser line.
Hand Positioning
(see figure K)
Keep hands, fingers and arms away from the ro-
tating saw blade.
Do not cross your arms when operating the tool
arm.
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Mitre/Bevel Angle
Horizontal Vertical
0° 0°
45° 0°
0° 45°
45° 45°
Height x Width
50 x 110 mm
37 x 110 mm
50 x 76 mm
37 x 76 mm
Bosch Power Tools