System Master Sheet; Manufacturer; Purpose; Changes To The Design / Construction - Nussbaum ATT COMBI LIFT CL 4.40 S Instrucciones De Servicio

9

System master sheet

9.1

Manufacturer

Otto Nußbaum GmbH & Co.KG
Korker Straße 24
D-77694 Kehl-Bodersweier
9.2

Purpose

The lift is a lifting tool for raising vehicles up to a total weight or 4,500 kg, for a maximum lift distribution
of 2:1 in the drive-in or against the drive-in direction. If the lift is fitted with a wheel jack the load carrying
capacity is 4,000 kg.
The wheel jack is a lifting tool for raising vehicles up to a total weight or 3,500 kg, for a maximum lift distri-
bution of 2:1 in the drive-in or against the drive-in direction.
The lift has been designed for stopping under the load receiving fixture. It is not set up for stepping onto
the drive-in rails or for conveying people. The set up of the standard lift is not permitted in explosion
endangered work shops and washing halls.
After construction and maintenance changes on load carrying parts the lift must be inspected after-
wards by a specialist who approves the changes. If the set up location is changed, the lift must be che-
cked again by a specialist and changed approved.
9.3

Changes to the design / construction

Inspections by a technical expert are required before recommissioning (date, type of change, technical
expert signature).
..................................................................................................................................................................................
..................................................................................................................................................................................
Name, address of technical expert
...................................................................................... ......................................................................................
Location, date
9.4

Changing the assembly location

Inspections by a technical expert are required before recommissioning (date, type of change, specialist
signature).
..................................................................................................................................................................................
..................................................................................................................................................................................
Name, address of technical expert
...................................................................................... ......................................................................................
Location, date
20110006 OPI 25.09.2015 COMBI LIFT 4.40 S-S A-S PLUS-S PLUS AMS - HYMAX II 4000 S-S A-S PLUS-S PLUS AMS
Technical expert signature
Technical expert signature
59