Single Safety Inspection Before Commissioning - Nussbaum ATT COMBI LIFT CL 4.40 S Instrucciones De Servicio

14

Single safety inspection before commissioning

i Copy, complete and leave in the inspection book
Test step: OK = "o" Defective or missing = "-" Post-inspection = "N"
Model plate
Operating manual
Label (e.g. warning label)
Lockable main switch
General condition of lift
Cover condition
Condition/ function ramps
Condition / function rollover / rollback safety
Condition of the joint bolts and bearing seating
condition of concrete floor (cracks)
Fastening anchor torque
Fastening screw torque
Load bearing construction (deformations, cracks)
Condition of weld seams
Tight seating of all load carrying screws
Condition of load cable and hanging ele-
ments
Condition of cable rollers
Unit condition
*) Enter one of the following: "o" = OK, "-" = defective or missing and/or "N" = reinspect!
Remarks: __________________________________________________________________________________________
____________________________________________________________________________________________________
____________________________________________________________________________________________________
Safety inspection done on: ___________________________________________________________
Performed by company: _____________________________________________________________
Name, address of specialist: __________________________________________________________
Result of inspection:
______________________________
Signature of specialist
If requested to take care of deficiencies
Deficiency removed on: ____________________________
(use a new form for reinspection!)
20110006 OPI 25.09.2015
Continued operation questionable, reinspection required
Continued operation possible, remove defects by ___________________
No deficiencies, continue to operate
COMBI LIFT 4.40 S-S A-S PLUS-S PLUS AMS - HYMAX II 4000 S-S A-S PLUS-S PLUS AMS
Serial number: _________________________________
Hydraulic oil filling level
condition of hydraulic lines incl. screw fittings
Hydraulic system leak-tightness
Cylinder condition
Condition wiper cylinder
Piston rods surface condition
Condition of the catch bar
Condition / function of catch magnet and catch
Paint condition
Condition of electrical lines and plug con-
nections
Condition of operating elements
Function button "LIFT, LOWER"
Function button "Lower into catch"
Function CE stop and warning signal
Function cable break, loose cable switch
Functional test system with vehicle
Condition sliding parts
Cover conditions
______________________________
Operating company signature
______________________________
Operating company signature
77