Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 2
2. Attach three Drawer Slides (Cabinet Side Left) (V2) to the front Vertical Support (X) and the Back
Vertical Support (Y) with #6 x 5/8" Undercut (type 17) Screws (R) into the pre-punched holes in the
supports. The notches in the vertical supports must face toward the bottom and away from each
other. Align the slides flush with the outer edge of the vertical supports with the wheels to the
front. See Figure 2.
Repeat the above steps on the opposite side of the vertical supports with the Drawer Slides (Cabinet
Side Right) (V1).
I
I
Z
X
Fig. 3
3. Using one #8 x 1-5/8" Black Screw (Z) in each center hole of the sleepers, attach a Sleeper (I) into
the predrilled hole in the top edge of each Vertical Support (X & Y). The notches in the sleepers must
face each other and the outer edges must be flush with the front and back edges of the vertical
supports. See Figure 3.
Turn the assembly over and attach the lower sleepers in the notches of the vertical supports with
#8 x 1-5/8" Black Screws (Z). Use the center holes in the sleepers and the pre-punched hole in the
notch on the supports. The notches on these sleepers must face toward the bottom of the unit. See
Figure 3a.
R
R
V2
X
V2
V2
Z
Y
Y
Fig. 3a
Z
586Wd — Page 5 — 03/14
Publicidad
