Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Display
After draining 5 minutes, it
still does not reach to water
E1
level
The top lid is open when
E2
spinning
Spin does not balance
E3
Inlet water for 50 minutes,
but it still does not reach to
E4
the setting water level
The water level is more
E6
than overflowing water
level.
F1
Water level sensor is wrong
2. Imbalance adjustment
During spinning, if the laundries are not placed equally in the tub, it would
cause violent vibration. This machine has imbalance adjustment function, and
the vibration testing system will supervise the running. Once vibration is
beyond certain level, the adjustment system will start automatically to adjust
the imbalance.
3. Power supply is cut off automatically
(1)If do not press START/PAUSE in 10 minutes after pressing POWER, power
supply will cut off automatically.
(2) Washing finished, power supply will cut off automatically .
Other functions
Explanation
15
Settlement
Open top Jid, according to previous
troubleshooting and settlement to
settle it ,then close the top lid and
clear up the alarm.
Close the top lid and clear up the
alarm
Open the top lid ,make the laundries
place equally, then close it and clear
up the alarm
Open top lid, according to previous
troubleshooting and settlement to
settle it. Then close the tip lid and
clear up the alarm
Drain the water until the water level
reaches the highest water level.
Cut the power supply and call the
technicians
Publicidad
