Home Decorators Collection HAYDEN LAKE Guía De Uso Y Cuidado página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
NOTE: The magnet is pre-attached on the canopy bottom
cover (EE) for you to remove and install easily.
□
Pull off the canopy bottom cover (EE) from the canopy (C).
□
Loosen the two canopy screws (DD) located in the
bottom of the mounting bracket (A), and turn the canopy
counterclockwise to remove the mounting bracket (A)
from canopy (C).
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew (FF)
must be completely tightened.
NOTE: This fan is equipped with a safety tab (HH).
Should the setscrew (FF) ever become loose while
the fan is running in reverse, the safety tab (HH) will
engage and stop the fan from falling.
□
Loosen, but do not remove, the setscrew (FF) on the collar (GG)
on top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar (GG),
and turning it clockwise until it is tight.
□
Re-tighten the setscrew (FF) on the collar (GG) on top of the fan-
motor assembly (E).
2
Routing the wires
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (EE).
□
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
A
DD
C
EE
7
FF
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
EE
D
B
E
EE
B
HH
GG
E