Checking For Blockages - Shark Navigator Lift-Away Zero-M Speed ZU560 Serie Manual Del Propietário

MAINTENANCE
Zero-M Technology
™
Zero-M Technology™ actively removes hair wrap from your brushroll while you vacuum, with
uncompromised cleaning power. If you run over a hard or sharp object or notice a noise change
while vacuuming, check for blockages or objects caught in the brushroll.
NOTE: Do not be alarmed if there is visible hair at any given time, as it will eventually make its way to
the dust cup.
CLEANING THE BRUSHROLL
Using a coin, turn locks counterclockwise, then open the door to access Brushroll.
NOTE: Door hinges open but is not completely removable.
DEBRIS WRAPPED AROUND BRUSHROLL
Clean off any debris on the bristles.
NOTE: If any hair is wrapped around the brushroll,
extending cleaning time will allow Zero-M™ technology to
remove it for you. If some fibers remain wrapped around
brushroll after continued use, carefully cut debris with
scissors and remove from brushroll.
s h a r kc l e a n . c o m
WITH
™
TECHNOLOGY
DEBRIS BEHIND BRUSHROLL
If you run over a hard or sharp object or notice
a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
Clear away any dust, dirt, or blockages in
Debris Intake.
To close the cover, push down until it clicks into
place, then close the locks with a coin.

CHECKING FOR BLOCKAGES

Detach hose from vacuum pod, and check hose
and opening on back of pod for blockages.
Detach wand from floor nozzle, tilt nozzle neck
back, and check opening for blockages.
Detach dust cup from vacuum pod. Empty dust
cup, remove debris from lint screen, and check for
blockages.
Detach wand from floor nozzle and handle, and
check both ends for blockages.
Detach handle from wand and hose from the
vacuum pod, and check openings for blockages.
s h a r kc l e a n . c o m