Sony CMT-T1 Manual De Instrucciones página 6

Inserting the
batteries
Insert two R6 (size AA) batteries into the
supplied remote.
Battery life
You can expect the remote to operate for about
six months using Sony SUM-3 (NS) batteries
before the batteries run down. When the
EN
batteries no longer operate the remote, replace
6 both batteries with new ones.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
Chapter 1: Setting up
Setting the Clock
You need to set the clock before using the
timer function.
1
1
Press TIMER SET.
2
Press TIMER+ or – to display "CLOCK"
and press ENTER.
The hour indication begins flashing.
AM
1 2 0 0
3
Set the current hour by pressing
TIMER+ or – and press ENTER.
The minute indication begins flashing.
AM
8 1 0
4
Set the current minute by pressing
TIMER+ or – and press ENTER.
The clock starts operating.
To correct the clock setting
Repeat steps 1 to 4.
About the time indication
• The built-in clock shows the time in the
display when you press POWER to turn off
the power.
• The upper dot of the ":" in the time display
flashes for the 0 to 29 seconds of the minute
and the lower dot flashes for the 30 to 59
seconds.
2, 3, 4
ENTER