Speed Selection - Beper VE.114 Manual De Instrucciones

Stand Fan Use instructions
PRODUCT AND ACCESSORIES Fig.1
1 – Front grid
2 – Closure nut
3 – Nut blades
4 – Blades
5 – Rear grid nut
6 – Rear grid
7 – Motor
8 – Swing button
9 – Body motor
10 – Inclination set button
11 – Timer
12 – Control panels
13 – Screw for pipe
14 – Internal pipe
15 – External pipe
16 – High adjustment handle
17 – Screw pipe coupling with Clamping washer
18 – Base
ASSEMBLY INSTRUCTIONS
1 – Put the base (18) on the floor.
2 – Insert completely the internal pipe (14) inside the external pipe (15).
3 –Fix the high adjustment handle (16).
4 – Fix the external pipe (15) to the base (18) with the screw (included in packaging).
5 – Take off the external pipe (14), and regulate it until the desired height. Strongly screw the high
adjustment handle (16).
6 – Place the control panels (12) on the pipe.
7 – Screw completely with the screw (14) in order that the control panels is well fixed to the intern
pipe (14).
8 – Place the rear grid (6) on the motor, in order that the holes of the grid are well inserted into the
motor of the fan
9 – Strongly and completely screw the rear grid (5) in order to block the grid on the motor.
10 – Insert the blades of the fan (4) on the motor (7) and completely screw the nut blade (3) on the
motor, in order to block the body motor.
11 – Assembly the 2 grid front (1) and rear ones (6) by inserting the closure nut (2), place the front
grid (1), on the rear grid (8). Close the nuts (2) to block the grids.

SPEED SELECTION

Choose the speed desired pressing on the buttons of the control panels (12).
Position 0 the fan switch off.
Position 1 low speed.
Position 2 medium speed.
Position 3 high speed.
10