Cardin Elettronica INTBT C4 Manual página 7

TECHNICAL DATA
Power supply
Maximum electrical input:
Maximum commutable power at the relay with resistive load
(excluding light bulbs):
- load ac/dc
- maximum voltage
- maximum electrical input
Relay activation delay time
Operating temperature range
Depending on the type of installation, work out the position in which the interface will be situated remembering
that the site must be:
- indoors (or stored in a waterproof container if installed outdoors)
- a position safe from accidental collision;
- in a position which the technician can easily reach.
Fastening:
• To the wall, distance between centres 75 mm, using two M4 screws and relative rawlplugs (not supplied)
• In a waterproof container using the supplied double-sided adhesive tape.
Warning! The receivers must only be powered by a safety power pack.
The use of non-safety power packs could cause damage to the system.
To facilitate the electrical connection the container is fitted
with a slot-in terminal board cover which can be easily
removed using a small screwdriver.
INSTALLING THE INTBTC4 INTERFACE
12/24Vac-dc
50mA
60VA/24W
30Vac-dc
1 A
80-100ms
-10° ...+55°C
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable
Drawing number :
DM0275
RXRADO
Product Code :
Date :
Draft : P.J.Heath
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
7
OVERALL DIMENSIONS
Description : (dimensioni d'ingombro)
RXRADO
21-05-97