Home Decorators Collection HD0547G Guía De Uso Y Mantenimiento página 7

Installation (continued)
5
Trimming excess fixture wire
□
Unthread the canopy lock ring.
□
Slide the canopy lock ring and the ceiling canopy (EE) down
the quick link (DD).
□
Push all slack fixture wire through canopy chain loop and into
the outlet box.
□
Trim excess fixture wire leaving a minimum of 6 inches
hanging out of the outlet box.
□
Separate the smooth side and ribbed side of the supply wire to
about 3 inches from the end.
□
Using wire strippers, strip each wire ½ inch from the end.
6
Making the electrical connections
* Use wire connectors (CC) to connect the wires.
□
Ground wire:
□
Wrap the supply ground wire around the green ground screw
on the crossbar assembly (AA), no less than 2 in. from the end
of the wire. Tighten ground screw.
□
Connect the fixture ground wire to the supply ground wire
with a wire connector (CC).
□
Supply wire:
□
Connect the house white wire to the fixture supply wire
(ribbed sided) identified with the label "N. "
□
Connect the house black (or red) wire to the fixture supply
wire (smooth side) identified with the label "L."
□
Wrap each connection with approved electrical tape and
carefully insert all of the connected wires into the outlet box.
DD
EE
DD
White wire from supply
Black (or red)
wire from supply
Ground wire
from supply
Green ground screw
7
Please contact 1-800-986-3460 for further assistance.
Supply wire
and ground wire
Canopy lock ring
CC
Ribbed side of wire from
fixture identified with the
label "N"
Smooth side of wire from
fixture identified with the label "L"
Ground wire from fixture
identified with the label "G"
HOMEDEPOT.COM/HOMEDECORATORS