Gaggia La Precisa EL1 Uso Y Mantenimiento página 70

English
Press the T3 button of the brew group you want to copy
the doses to (destination group).
Copying is instantaneous, and the T3 button of the
destination brew group flashes rapidly for 3 seconds.
The machine then goes back to copy mode: to exit this
mode, press the T3 button of the original group.
7.3 Coffee brewing
By pressing the corresponding button (T1-T2-T4 or T5),
the corresponding dispensing solenoid valves are activated
until the previously programmed product quantity
(volumetric control) is reached.
The LED of the selected dose remains switched on for the
entire coffee dispensing time.
The brewing in progress can be suspended before actually
reaching the desired programmed product quantity by
pressing any of the dose keys on the keypad of the group
used for product brewing.
It is also possible to obtain simultaneous coffee brewing
from all the machine groups.
70
7.4 Continuous coffee doses
Press the T3 key of the keypad corresponding to the
group to be used in order to obtain the continuous coffee
brewing.
The LED of the T3 key remains on for the entire coffee
dispensing time.
Avoid keeping it pressed
for more than 5 seconds
or it will
programming mode.
Coffee will be brewed until a dose stop by pressing any of
the dose button of the group used or until the maximum
quantity of product is reached through a volumetric check
(6000 pulses) or a dispensing time-out.
The "Continuous"
STARTS when the T3
button is released (within 5
seconds), not when it is
pressed. To STOP the
cycle, touch the button
again a second time, or any
other one of coffee brew
group.
enter the
cycle