Descargar Imprimir esta página

Makita HR4510C Manual De Instrucciones página 6

Ocultar thumbs Ver también para HR4510C:

Publicidad

Idiomas disponibles

Idiomas disponibles

For chipping, scaling or demolition operations, depress
the lock button and rotate the change lever so that the
pointer points to the
symbol. Use a bull point, cold
chisel, scaling chisel, etc.
CAUTION:
Do not rotate the change lever when the tool is
running under load. The tool will be damaged.
To avoid rapid wear on the mode change mech-
anism, be sure that the change lever is always
positively located in one of the two or three
action mode positions.
Torque limiter
The torque limiter will actuate when a certain torque
level is reached. The motor will disengage from the out-
put shaft. When this happens, the bit will stop turning.
CAUTION:
As soon as the torque limiter actuates, switch
off the tool immediately. This will help prevent
premature wear of the tool.
Indicator lamp
1
2
► 1. Power-ON indicator lamp (green) 2. Service
indicator lamp (red)
The green power-ON indicator lamp lights up when the
tool is plugged. If the indicator lamp does not light up,
the mains cord or the controller may be defective. The
indicator lamp is lit but the tool does not start even if the
tool is switched on, the carbon brushes may be worn
out, or the controller, the motor or the ON/OFF switch
may be defective.
The red service indicator lamp lights up when the car-
bon brushes are nearly worn out to indicate that the tool
needs servicing. After approx. 8 hours of use, the motor
will automatically be shut off.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Side handle
CAUTION:
Use the side handle only when chipping, scaling
or demolishing. Do not use it when drilling in
concrete, masonry, etc. The tool cannot be held
properly with this side handle when drilling.
The side handle can be swung 360° on the vertical and
secured at any desired position. It also secures at eight
different positions back and forth on the horizontal.
Just loosen the clamp nut to swing the side handle to a
desired position. Then tighten the clamp nut securely.
1
2
► 1. Side handle 2. Clamp nut
Side grip
► 1. Side grip
6 ENGLISH
1

Publicidad

loading

Este manual también es adecuado para:

Hr4511c