Makita JV001G Manual De Instrucciones página 7

Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Press the lock switch to turn on the lamp. Press the lock
switch again to turn off the lamp.
2 1
Fig.4
► 1 . Lock switch 2. Lamp
NOTICE:
When the tool is overheated, the lamp
blinks. Cool down the tool fully before operating
the tool again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Switch action
To turn on the tool, press the lock switch. The tool turns
into the standby mode. To start the tool, press the ON/
standby switch in the standby mode. To stop the tool,
press the ON/standby switch again. The tool turns into
the standby mode. To turn off the tool, press the lock
switch in the standby mode.
1
2
Fig.5
► 1 . Lock switch 2. ON/standby switch
NOTE: If the tool is left for 10 seconds without any
operation in the standby mode, the tool automatically
turns off and the lamp goes off.
NOTE: You can also stop and turn off the tool by
pressing the lock switch while the tool is operating.
To decreases the brightness of the lamp, press and hold the lock
switch when turning into the standby mode. About 1 second after you
start pressing the lock switch, the brightness of the lamp will start
to decrease, so release the lock switch when you reach the desired
brightness. It turns the tool into standby mode, too. About 3 seconds
after you start pressing the lock switch, the brightness of the lamp will
be minimized and the brightness will not change after that.
NOTE: The brightness of the lamp cannot be adjusted
while the tool is in standby mode. Turn off the tool to
decrease the brightness of the lamp.
NOTE: There is no memory function for the brightness
of the lamp. If you turn the lamp off and then turn it on,
the brightness of the lamp will be maximized each time.
Speed adjusting dial
Fig.6
► 1 . Speed adjusting dial
The tool speed can be adjusted by turning the speed adjusting
dial. You can get the highest speed at 6 and the lowest speed at 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed may
differ with the type or thickness of the workpiece. In gen-
eral, higher speeds will allow you to cut workpieces faster
but the service life of the jig saw blade will be reduced.
Workpiece
Wood
Mild steel
Stainless steel
Aluminum
Plastics
NOTICE:
The speed adjusting dial can be turned
only as far as 6 and back to 1. Do not force it past 6 or
1, or the speed adjusting function may no longer work.
Electronic function
The tool is equipped with the electronic functions for easy operation.
Soft start
The soft-start function minimizes start-up shock, and
makes the tool start smoothly.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the rotating speed is
kept constant even under load condition.
7 ENGLISH
1
Number
4 - 6
3 - 6
3 - 4
3 - 6
1 - 4