Publicidad
!
Fitting the Brush / Pad / Turn on water
400mm Brush / 360mm Pad.
Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
Slide the brush / pad under the brush deck.
Fit the brush / pad onto the Nulock drive chuck, twist to lock the brush / pad in place.
Safety gloves are recommended for the changing of used brushes.
Turn on the clean water tap.
Fitting the Floor-tool
The floor-tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off feature if the
floor-tool gets snagged, whilst in transit.
NOTE: It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
1
Swing the floor-tool carrier to the
side of the machine. (Fig.1).
Secure to the carrier using the two
knobs fitted to the floor-tool carrier
(Fig.2) - (Fig.3).
Do not over tighten the retaining
knobs.
Ensure inspection cap is in place on
the fluid pipe. (Fig.4) - (Fig.5)
For fitting the floor-tool blades
(See Page 10).
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
2
4
15
Machine Set-up Guide
3
5
!
Publicidad
